[amsat-bb] Re: Icom 910H aux switching

[Rick Vidmar - K9KK]

I also found the ICOM-910 lacking a keying output for a POWER AMP.
AND, I think it is a good idea.
Scott Townley's response is definitely the reason.
A sequencer must be used to get the correct keying delay for the PWR AMP
or you can kiss your preamp good buy.  The sequencer fires the PWR AMP and 
PRE AMP at appropriate times to ensure that you don't blow the PRE AMP.
I use the SSB Electronics sequencer and key it with a connection from my
DESK MIKE.

----- Original Message ----- 
From: "Keith Le Boutillier" <gu6efb@cwgsy.net>
To: <amsat-bb@amsat.org>
Sent: Saturday, September 02, 2006 6:23 AM
Subject: [amsat-bb] Icom 910H aux switching


> Hi
>
>
> I wish to switch my amp and pre amps when using the Icom 910H
>
> Is their any way of having a switching line the changes when the rig goes
> into TX
> I have read the manual and checked the sockets on the back of the rig but
> can't see an aux switching line or voltage change or anything that I could
> use.
>
> Dose anyone have any advice or achieved what I wish to do
>
> 73 Keith GU6EFB
>


--------------------------------------------------------------------------------


No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.405 / Virus Database: 268.11.7/436 - Release Date: 01/09/2006



--------------------------------------------------------------------------------


> _______________________________________________
> Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author.
> Not an AMSAT-NA member? Join now to support the amateur satellite program!
> Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
>