[amsat-bb] Re: SatPc32 question on W0LMD server rotor control setup

[Erich Eichmann]

Hello Dick,
the north centered G-5400 has its turning point (= rotor end points) in the
South. Therefor check South. With the tracker itself the setting must be
done with dip switch #4, see tracker manual.
73s, Erich, DK1TB

----- Original Message ----- 
From: "Dick Williams" <k8ztt at mho.com>
To: <amsat-bb at amsat.org>
Sent: Thursday, July 10, 2008 1:13 AM
Subject: [amsat-bb] SatPc32 question on W0LMD server rotor control setup


> In the setup box for the "Server W0LMD"  can someone tell me what should
> be checked in the "Azimuth rotor turns in" box?? The two choices are South
> and North.   I am using the Yaesu G-5400 with a north center.
>
> I can't find anything about the setting in the SatPC32 manual nor the
> setup section for the W0LMD control box.
>
> Thanks
>
> Dick K8ZTT
> _______________________________________________
> Sent via AMSAT-BB at amsat.org. Opinions expressed are those of the author.
> Not an AMSAT-NA member? Join now to support the amateur satellite program!
> Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
>