[amsat-bb] Re: ICOM 471A Output N Connector replacement

[G. Beat]

Mike - 



Contact Scott Malcom, KA7MEF Technician and Lead Go'fer at MTS Repair. 

  

Scott worked for Icom Service, when this radio was new, and should be able to provide 

the necessary insight for your work.  

He also has access to some parts from junked/donor radios of that classic Icom era. 



Malcom Technical Support (MTS) 
5130 Jackson Hwy 
Toledo, WA 98591-8680 

Email: mts at toledotel.com 

Voice Mail: 360 864 8438 




eHam.net reviews (126) scoring 4.9 out of 5.0 (excellent rating) 

http://www.eham.net/reviews/detail/1786 



greg 

w9gb 



------------------------------ 

Message: 8 
Date: Tue, 15 Jun 2010 06:16:31 GMT 
From: "mike casey" <doomsdaymike at netzero.com> 
Subject: [amsat-bb]  ICOM 471A Output N Connector replacement 
To: amsat-bb at amsat.org 
Message-ID: <20100615.021631.26462.0 at webmail05.dca.untd.com> 
Content-Type: text/plain; charset=windows-1252 

Has anyone replaced the female N connector on the IC 471A, 25 watt tranceiver PA module? It seems as if the heat sink is trapped between the N connector barrel and the PA circuit board. Unless the connector barrel pulls off of the pin, I see no way of removing it, or the circuit board to get at the pin. I don't want to use to much force in pulling off the barrel. Perhaps heating the pin might release the barrel. Any suggestions? Should I send it to Icom and let them worry about it? 
____________________________________________________________