[amsat-bb] Guess I need Help with Fox-1A Software and IC910

[Andrew Glasbrenner]

You can't use regular audio, because it has the low frequencies we are using
for the data filtered out. That includes the sound through your Signalink.

Use must either use an SDR source, or the audio from the data out pin on the
back of your radio. Section 4.3 in the manual.

73, Drew KO4MA

-----Original Message-----
From: AMSAT-BB [mailto:amsat-bb-bounces at amsat.org] On Behalf Of Bob KD7YZ
Sent: Thursday, October 08, 2015 8:08 PM
To: AMSAT BB
Subject: [amsat-bb] Guess I need Help with Fox-1A Software and IC910

Disappointing. I normally decode ARISS as well as local APRS.
I heard the Voice ID gal very strongly, numerous times.
The program was set to get audio from the SignaLink USB just as MixW and
UISS are. Though they were no loaded.

On the IC910, I set "9600" on then after a while OFF then switched it back
again later.

Got no decodes nor heard anything in the form of a signal except the
Fox1 Safe Mode gal.


Can I get some guidance before nest pass?

thanks

--
73,
Bob KD7YZ
www.qrz.com/db/kd7yz
AmSat LM#901
_______________________________________________
Sent via AMSAT-BB at amsat.org. AMSAT-NA makes this open forum available to all
interested persons worldwide without requiring membership. Opinions
expressed are solely those of the author, and do not reflect the official
views of AMSAT-NA.
Not an AMSAT-NA member? Join now to support the amateur satellite program!
Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb