[amsat-bb] SatPC32 and HDSDR

[Erich Eichmann]

Tom,
I tested that with the FCDP+ as Radio 1 and the FT-847 as Radio 2. I 
added an additional  line for FO-29 to Doppler.SQF with reverse SSB 
modes (downlink LSB, uplink USB).  When I switched between the data 
lines (menu CAT) the modes changed in HDSDR and at the FT-847.
Settings:
Radio 1: Kenwood, TS-2000, baudrate 57600, same baudrate in HDSDR, CAT 
delay 50.
Radio 2: Yaesu FT-847, baudrate 57600
All options in menu Radio Setup unchecked.

73s, Erich, DK1TB

Am 13.07.2017 um 06:28 schrieb Tom Schuessler:
> All,
>
> A quick question on using SatPC32 to control HDSDR.  I have a FCDP+ and can
> control it via CAT via virtual Serial Port Emulator software.  I seem to
> have some success using the Kenwood TS 2000 settings for Rig for this
> software/device.  Problem is that when I select a Doppler.SQF line in the
> CAT dialog, HDSDR changes to the wrong SSB mode.  I have to manually change
> it to USB on HDSDR.  FM works fine, but SSB modes start out wrong.  Is there
> a better radio emulation to use than the TS 2000?
>
> Also, If I want to use the HDSDR/FCDP+ as the RX and my FT847 as TX, which
> radio should best be radio 1 and which should be 2?
>
> Thanks much.
>
> Tom Schuessler
> N5HYP
>
>
> _______________________________________________
> Sent via AMSAT-BB at amsat.org. AMSAT-NA makes this open forum available
> to all interested persons worldwide without requiring membership. Opinions expressed
> are solely those of the author, and do not reflect the official views of AMSAT-NA.
> Not an AMSAT-NA member? Join now to support the amateur satellite program!
> Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb