[amsat-bb] SatNOGS

[Saint Aardvark]

Hi Mike - I’m about to start a build of the v3 rotator (though due to inexperience and time limits, it’s liable to be a long-term project). I’d definitely recommend searching through the forum (https://community.libre.space) for previous messages from people building them, and posting there if you run into any problems - the devs are always looking for ways to improve the project and it’s documentation.

Best,
Hugh

Saint Aardvark the Carpeted
https://saintaardvarkthecarpeted.com
Because the plural of Anecdote is Myth.

> On Feb 17, 2018, at 13:11, Mike Hoblinski <hobergenix at gmail.com> wrote:
> 
> Has anybody built the open  source V3 antenna rotor from the SatNOGS site.
> 
> Website https://satnogs.org/
> Wiki https://wiki.satnogs.org/Main_Page
> 
> They promote an open source ground station and link them up. They use a
> Raspberry Pi as the computer board and have a controller board that drives
> steppers or DC motors for Az and El.
> 
> Mike Hoblinski
> N6IMF
> _______________________________________________
> Sent via AMSAT-BB at amsat.org. AMSAT-NA makes this open forum available
> to all interested persons worldwide without requiring membership. Opinions expressed
> are solely those of the author, and do not reflect the official views of AMSAT-NA.
> Not an AMSAT-NA member? Join now to support the amateur satellite program!
> Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb