[amsat-bb] satpc ver D ?

[Robert Switzer]

Erich replied to me when I asked:
"
Hi, the program centers the map on your locator only with the zoom 1 (Z1) map. The zoom 2 map is always centered on the satellite to avoid that the satellite is outside the program window. In menu 'Options' un-check start option 'zoom 2', and save the change if you want the program to start with the map centered on you QTH.
73s, Erich, DK1TB"
I don't think I ever used used anything other than zoom 1 prior... so I didn't even think to check zoom mode after installation.
Rob KA2CZU
 

    On Thursday, February 22, 2018, 2:52:15 AM EST, Wayne Estes <w9ae at charter.net> wrote:  
 
 Jim Ki7WJ wrote:

Upgraded to the new ver D SAT32 and working ok. I haave the Observer 
stored and is correct for my QTH(Reno), however the map does not center 
on the qth or the U.S.? unless I engage a satellite specifically. Am I 
missing something in the set up?
ThanksJim KI6WJ

Wayne W9AE replies:

Go into the Setup -> Options menu and make sure that "center map on 
observer" is enabled.

Wayne Estes W9AE
Oakland, Oregon, USA, CN83ik
_______________________________________________
Sent via AMSAT-BB at amsat.org. AMSAT-NA makes this open forum available
to all interested persons worldwide without requiring membership. Opinions expressed
are solely those of the author, and do not reflect the official views of AMSAT-NA.
Not an AMSAT-NA member? Join now to support the amateur satellite program!
Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb