[amsat-bb] Cables loss

[Dave .]

While I'm still new to the sats I have been doing VHF/UHF weak signal work
since the 80's and I've always preferred to spend the money on feedline
rather than pre-amps. Given that pre-amps amplify the rx noise and signal
you really don't improve signal to noise unless the noise figure of the
pre-amp is better than your receiver. Usually your just amplifying the
signal to make up for the loss that's going to happen as the signal makes
it's way down the coax.

You also add complexity when you want to TX on the antenna since you will
need to add a t/r relay at the antenna. In addition, you are still losing
tx power with the higher loss cable so depending on your ERP goal you may
need an amplifier, generally not an issue with the LEO's.
LMR-600 or hardline is my feedline of choice for 2m and up. I'm not
suggesting that pre-amps can't or shouldn't be used but usually aren't
needed if good low loss feedline is used to begin with.

Dave
N2OA

On Thu, Jul 19, 2018 at 9:17 AM Roger Titmuss <OLDBIKER at sky.com> wrote:

> Hi as a newcomer to this part of the hobby I have a couple of questions.
>
>
>
> 1. When using the M2 egg beaters how important is it to install a masthead
> preamplifier?
>
>
>
> 2. Again with egg beater will 30 watts be enough to get back to the bird?
>
>
>
> I am using about 80 feet of RG213 to connect the antenna.
>
>
>
>
>
> Many thanks
>
>
>
> Roger G0AWY
>
>
>
> 73
>
> _______________________________________________
> Sent via AMSAT-BB at amsat.org. AMSAT-NA makes this open forum available
> to all interested persons worldwide without requiring membership. Opinions
> expressed
> are solely those of the author, and do not reflect the official views of
> AMSAT-NA.
> Not an AMSAT-NA member? Join now to support the amateur satellite program!
> Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb
>