[amsat-bb] SATPC32 - Is there a way to adjust downlink only?

[John Kludt]

Bob,

Open the CAT option on the top bar.  Inside you will find to adjustment
girds, one of RX and one for TX.  I think that will accomplish what you are
trying to do.  On my IC-901H is use the RIT control which is good for samll
cahnges.  If more than that I just retune my VFO to their frequency.

John


On Fri, Feb 15, 2019 at 2:41 PM Bob <WB4SON at gmail.com> wrote:

> Hi,
>
> I'm using an Icom IC-9100 and the RIT control is almost useless as it
> changes frequency very slowly.  To change 1 KHz takes about 15 seconds, a
> lifetime on a pass.  In other words if a station calls me and they are a
> KHz off, then they will be off the air before I can get the RIT set.
>
> I'm running SatPC32 v 12.8d.  The manual implies that there are Downlink
> adjustments when the V+ mode is turned on, but I only see uplink
> adjustments to the right of the frequency display that can either be moused
> up/down, or respond to the +/- keys.
>
> Perhaps there is something else that would open Downlink adjustment to the
> left of the display?  Or maybe other keys that adjust the Downlink?
>
> 73, Bob, WB4SON
> _______________________________________________
> Sent via AMSAT-BB at amsat.org. AMSAT-NA makes this open forum available
> to all interested persons worldwide without requiring membership. Opinions
> expressed
> are solely those of the author, and do not reflect the official views of
> AMSAT-NA.
> Not an AMSAT-NA member? Join now to support the amateur satellite program!
> Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb
>