[amsat-bb] SatPC32 Stalls at AOS
Mark D. Johns
mjohns+K0JM at luther.edu
Wed Feb 20 11:48:23 UTC 2019
FlexSatPC current version is v.8.7.4. Your version is pretty old. You may
be due for an update.
On Tue, Feb 19, 2019 at 23:39 Allen <burrell at teleport.com> wrote:
> Hi All,
> For several months I have been automatically receiving frames from the
> Fox-1 satellites. Typically at –3 degrees elev, the az/el sets the antenna
> position correctly and the radio is tuned to the correct frequency. But
> lately as soon as 0 degrees el is reached, SatPC32 stalls, the clock stops
> and nothing further happens until I manually click on the enabled
> satellite. Everything again proceeds normally, until the next scheduled
> satellite reaches 0 degrees el and SatPC32 stops. Since this error I
> upgraded from Ver 12.8c to 12.8d which produced the same error. I
> reinstalled 12.8c but the condition persists. In receive only mode, I’m
> using a Flex 1500 with FlexSatPC 7.2.2 and the computer uses Win10 Pro with
> an i7 processor and 8GM RAM. CPU demand always is less than 10%. I’m at a
> loss as to where to look to resolve this issue. Any guidance is greatly
> appreciated.
>
> 73, Allen KI7RM
> _______________________________________________
> Sent via AMSAT-BB at amsat.org. AMSAT-NA makes this open forum available
> to all interested persons worldwide without requiring membership. Opinions
> expressed
> are solely those of the author, and do not reflect the official views of
> AMSAT-NA.
> Not an AMSAT-NA member? Join now to support the amateur satellite program!
> Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb
>
--
--
Mark D. Johns
KØJM / MØGZO / ex-9H3DJ / ex-KØMDJ
Brooklyn Park, MN USA EN35hd
-----------------------------------------------
"Heaven goes by favor; if it went by merit,
you would stay out and your dog would go in."
---Mark Twain
More information about the AMSAT-BB
mailing list