[amsat-bb] Question about duplexer as a high-pass filter

[Bob]

Hi Steve,

I asked myself a similar question and decided to measure things both
terminated and un-terminated.  Bottom line is you want to terminate that
unused port.

Here is a story on my website:  https://wb4son.com/wpblog/?p=2828

73, Bob, WB4SON

On Sun, Nov 10, 2019 at 6:18 PM AI9IN via AMSAT-BB <amsat-bb at amsat.org>
wrote:

> My satellite rig is two HTs running to an Arrow antenna. Trying my best
> to operate full duplex. When operating V/U I am using the UHF side of
> the Arrow duplexer as a high pass filter between the UHF antenna feed
> point and the UHF HT to keep the 2 m transmit signal from desensing the
> UHF receive.
>
> But it only sort of works.
>
> This set up leaves the VHF end of the duplexer open and just hanging.
> Would this setup work better with a 50 ohm load across that empty
> connection? (Sorry if this is a dumb or elementary question, but I'll
> never find out if I don't ask.)
>
> All helpful insights are welcome.
>
> Steve AI9IN
> _______________________________________________
> Sent via AMSAT-BB at amsat.org. AMSAT-NA makes this open forum available
> to all interested persons worldwide without requiring membership. Opinions
> expressed
> are solely those of the author, and do not reflect the official views of
> AMSAT-NA.
> Not an AMSAT-NA member? Join now to support the amateur satellite program!
> Subscription settings: https://www.amsat.org/mailman/listinfo/amsat-bb
>