[amsat-bb] Re: F1 Telemetry Decoder

[Mark L. Hammond]

Hi Keith,

It's apparently setup to use hardware modems.  This shack loves hardware TNCs :) 

You might be able to get AWGPE working if you can send KISS data out to a virtual com port...check out http://www.soundcardpacket.org/

"In addition, Tim Pearson KB9VQF has written a <http://www.pearsoncomputing.net/freeware.php>AGWPE Serial Loopback utility that creates virtual serial ports that will let you link AGWPE to any packet program that can link to a KISS-enabled TNC (AGWPE's sound card mode simulates a KISS TNC). "



73,

Mark N8MH 

At 09:04 AM 9/30/2012 -0700, Keith O'Brien wrote:
>The F1 Telemetry Decoder Manual in Section 5.2.3 Decode Data OBC2
>*You should connect this program with your transceiver first.
>
>Not sure what they are looking for here. I would like to use AGW Packet Engine 
>as my packet TNC. Anyone offer any guidance in how to configure APWPE to the 
>F1 decoder program ? I also have MixW if that would work... 
>
>Keith N4ZQ
>
> 
>_______________________________________________
>Sent via AMSAT-BB at amsat.org. Opinions expressed are those of the author.
>Not an AMSAT-NA member? Join now to support the amateur satellite program!
>Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb