[amsat-bb] Re: F1 Telemetry Decoder

[Steve Daniels]

I found a way of using a software modem to send KISS to the decoder via a
serial port emulator.
Run this modem click activate APRS-SCS support (it only works with the
default soundcard)
http://www.tapr.org/~kb2scs/scs01.html
Download the following Virtual serial port
http://www.hw-group.com/products/hw_vsp/index_en.html
install as standalone
on the virtual Serial port tab select a free com port, ip address 127.0.0.1
and port 4000
run the decoder and connect to the port you setup.
Hope that helps



Steve Daniels
G6UIM
APRSISCE/32 Beta tester and WIKI editor http://aprsisce.wikidot.com
 

-----Original Message-----
From: amsat-bb-bounces at amsat.org [mailto:amsat-bb-bounces at amsat.org] On
Behalf Of Mark L. Hammond
Sent: 30 September 2012 17:30
To: Keith O'Brien; AMSAT-BB
Subject: [amsat-bb] Re: F1 Telemetry Decoder

Hi Keith,

It's apparently setup to use hardware modems.  This shack loves hardware
TNCs :) 

You might be able to get AWGPE working if you can send KISS data out to a
virtual com port...check out http://www.soundcardpacket.org/

"In addition, Tim Pearson KB9VQF has written a
<http://www.pearsoncomputing.net/freeware.php>AGWPE Serial Loopback utility
that creates virtual serial ports that will let you link AGWPE to any packet
program that can link to a KISS-enabled TNC (AGWPE's sound card mode
simulates a KISS TNC). "



73,

Mark N8MH 

At 09:04 AM 9/30/2012 -0700, Keith O'Brien wrote:
>The F1 Telemetry Decoder Manual in Section 5.2.3 Decode Data OBC2
>*You should connect this program with your transceiver first.
>
>Not sure what they are looking for here. I would like to use AGW Packet
Engine 
>as my packet TNC. Anyone offer any guidance in how to configure APWPE to
the 
>F1 decoder program ? I also have MixW if that would work... 
>
>Keith N4ZQ
>
> 
>_______________________________________________
>Sent via AMSAT-BB at amsat.org. Opinions expressed are those of the author.
>Not an AMSAT-NA member? Join now to support the amateur satellite program!
>Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
_______________________________________________
Sent via AMSAT-BB at amsat.org. Opinions expressed are those of the author.
Not an AMSAT-NA member? Join now to support the amateur satellite program!
Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb