[amsat-bb] Satpc32 control IC910

[KO6TZ Bob]

Jim,

In satellite mode, the IC910H puts the sub-band downlink on the top of 
the display and the main-band on the bottom.  This is reversed from the 
normal display.  Is this what you are referring to?

bob
ko6tz



I'm trying to set up an IC910 with SatPC32 to work with a VHF up / UHF
down satellite.

I've built a doppler.sqf entry with 435xxx as the downlink and 145xxx as
the uplink.  The 910 will only transmit on the main band so that needs
to be the VHF uplink. But SatPC32 puts the RX freq there, and the TX
freq in the sub band.

Also, what should be checked in the options in the radio setup window.
I have none checked at this time.

Is there a setting to change the main/sub tx/rx or can I just swap the
up and down freqs in the doppler.sqf entry?

Jim