[amsat-bb] JY1SAT Sat Warehouse

[Hasan al-Basri]

Graham,
I can't thank you enough. I now have 3 dashboards installed, FC-1, Nayaf-1
and JY1-Sat. I can run all at the same time, and I can also run 3 receivers
at a time, all feeding their audio streams to the software (SDRs are soooo
nice)

Awaiting my 1st nayaf-1 tlme pass (3 min AOS). Signals were quite strong
earlier, but I didn't have the right decoder software up yet.

Thanks again.
73, N0AN
Hasan


On Fri, Nov 16, 2018 at 10:27 AM Graham Shirville <graham at shirville.com>
wrote:

> Hi Hasan,
>
> Yes you site id authentication can be the same for all dashboards,
> currently FC1 and Nayif. You can also use the same id for the new ESEO
> and JY1SAT dashboard from next week (hopefully).
>
> If you are running the FC1 dashboard and it receives and decodes data
> from Nayif- it will send these to the Data Warehouse automatically. You
> will see the bottom RH count going up beyond the LH number. Youcan,
> usually run both dashbaords at the saem time if you wish to display
> everything!
>
> 73
>
> Graham
>
>
> On 16/11/2018 16:07, Hasan al-Basri wrote:
> > I've been decoding and uploading AO-73 data with the Funcube-1 Dashboard.
> >
> > I just downloaded and installed JY1-Sat Dashboard.
> >
> > IAre the Site ID (my call) and the Auth code the same for both upload
> sites?
> >
> > I should have a pass of EO-88 in about 30 minutes. Is there any
> indication
> > from the software that my data is being accepted at the site, based on
> the
> > same ID and Auth as for AO-73 ?
> >
> > TIA,
> > 73, N0AN
> > Hasan
> > _______________________________________________
> > Sent via AMSAT-BB at amsat.org. AMSAT-NA makes this open forum available
> > to all interested persons worldwide without requiring membership.
> Opinions expressed
> > are solely those of the author, and do not reflect the official views of
> AMSAT-NA.
> > Not an AMSAT-NA member? Join now to support the amateur satellite
> program!
> > Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb
>
>