[amsat-bb] Satpc32 and ICOM 9700

[Erich Eichmann]

Hi Mike,
your wrote:
"The issue I have is that about once a week, the SATpc32 and the radio 
fail to communicate. Then, I turn off the radio and shutdown SATpc32. 
Irestart both and it is fine for another week or so.

That has nothing to do with SatPC32 but is a problem of the USB port, I 
think. I noticed the same sometimes. Here it helps to unplug the USB 
cable from the PC and to plug it in again. With CAT control via the CI-V 
connector of the IC-9700 you would not have the problem.

73s, Erich, DK1TB


10.05.2020 um 06:03 schrieb Michael Walker via AMSAT-BB:
> Hi Rick
>
> I would have to say, my experience is not the same.  I use the VFO knob all
> the time, just like I was on 20M and I have never had an issue.  I actually
> does work as it should and it continues to doppler tune just fine.
>
> Mine is on the USB port.  Maybe we should compare settings.  If I had the
> problem you are seeing, I would try reducing the baud radio (or even try
> increasing it).  I am at 19200, but I bet you could safely run at 9600 as
> the amount of data being moved is pretty trivial.  I am away from my
> computer, but I think my interval speed is set to 30.
>
> The issue I have is that about once a week, the SATpc32 and the radio fail
> to communicate.  Then, I turn off the radio and shutdown SATpc32.  I
> restart both and it is fine for another week or so.
>
> Mike va3mw
>
>
> On Sat, May 9, 2020 at 9:33 PM Rick Kowalewski via AMSAT-BB <
> amsat-bb at amsat.org> wrote:
>
>> Would be nice if the USB settings "worked as advertised".
>>
>> If the VFO know is not moved, then yes, all is ok.  However, once you
>> start to tune around the bandpass, SatPC32 eventually 'loses' comms with
>> the 9700 and will not doppler tune.
>> However, not all comms are lost.  If you select another line in CAT
>> Tuning, the radio now changes to that frequency.  You can even select
>> another satellite and frequency/mode changes.  BUT, radio no longer
>> follows doppler tuning and tuning the VFO does not update on SatPC32.
>> Go figure.
>>
>> Have tried both http://www.dk1tb.de/IC9700_settings.htm and
>>
>> https://www.amsat.org/wordpress/wp-content/uploads/2020/01/SatPC32-IC9700-Setup-1.pdf,
>>
>> makes no difference.  Same under Win7 & Win10.
>>
>> Only cure is to restart Windows.
>>
>> 73,
>> Rick VK6RKsat-bb <https://www.amsat.org/mailman/listinfo/amsat-bb>
>>
> _______________________________________________
> Sent via AMSAT-BB at amsat.org. AMSAT-NA makes this open forum available
> to all interested persons worldwide without requiring membership. Opinions expressed
> are solely those of the author, and do not reflect the official views of AMSAT-NA.
> Not an AMSAT-NA member? Join now to support the amateur satellite program!
> Subscription settings: https://www.amsat.org/mailman/listinfo/amsat-bb